FAA: vers un instrument de plus sur nos tableaux de bord ?

AoA: un instrument appelé indicateur d’incidence (angle of attack indicator)

Exemple:
Capture d’écran 2014-03-07 à 13.01.02

Voir aussi http://www.bendixking.com/Products/Flight-Controls-Indicators/Indicators/KLR-10

Design Approval Requirements Simplified By The Agency

The FAA has taken an important step to help improve safety in small aircraft by simplifying design approval requirements for a cockpit instrument called an angle of attack (AOA) indicator. AOA devices, common on military and large civil aircraft, can be added to small planes to supplement airspeed indicators and stall warning systems, alerting pilots of a low airspeed condition before a dangerous aerodynamic stall occurs, especially during takeoff and landing.

An “angle of attack” is the angle between a plane’s wing and the oncoming air. If the angle of attack becomes too great, the wing can stall and lose lift. If a pilot fails to recognize and correct the situation, a stall could lead to loss of control of the aircraft and an abrupt loss of altitude. Stalls can happen during any phase of flight, but they are critical when planes are near the ground and have less room to recover, such as during landing and takeoff.

AOA indicators may help prevent loss of control in small aircraft because they provide a more reliable indication of airflow over the wing. Although they have been available for some time, the effort and cost associated with gaining installation approval has limited their use in general aviation. The streamlined requirements are expected to lead to greater use of the devices and increased safety in general aviation.

“We have eliminated major barriers so pilots can add another valuable cockpit aid for safety,” said FAA Administrator Michael Huerta. “These indicators provide precise information to the pilot, and could help many avoid needless accidents.”

Under the new policy, manufacturers must build the AOA indicator system according to standards from the American Society for Testing and Materials (ATSM) and apply for FAA approval for the design via a letter certifying that the equipment meets ATSM standards and was produced under required quality systems. The FAA’s Chicago Aircraft Certification Office will process all applications to ensure consistent interpretation of the policy.

The FAA believes this streamlined policy may serve as a prototype for production approval and installation of other add-on aircraft systems in the future.

Voir http://rgl.faa.gov/Regulatory_and_Guidance_Library/rgPolicy.nsf/0/EB0FAC0C1641509586257C76005E6274?OpenDocument